Automatic Constant Feed Speed Control: Automatic output voltage
adjustment in real time to ensure constant preset feedspeed
regardless of the weight change of the workpieces.
Automatic Frequency Adjustment: Automatic output frequency
adjustment in real time to make sure the load is always working at
its resonant frequency.
Automatic Resonant Frequency Search: Search out and output
the resonant frequency of the load. Other related parameters are
also set automatically
Counting: Count the number of workpieces. The controller will slow
down or stop when counting up to a preset value. (available on
SDVC34MRJ)
RS-485 Communication: All parameters of the controller can be
adjusted via RS-485.
Automatic Switch Sensor Type Recognition: The controller can
recognize and adapt to both PNP and NPN type switch sensors
Sync Output: Sync the output waveform of the slave controller with
that of the master controller to the same frequency and phase to
avoid the beat effect
Overvoltage Protection: If the input voltage is too high, the power
supply of the controller will shut down automatically to protect
itself.
Digital Overheat Protection: If the internal temperature of the
controller gets too high, the controller will stop its output to
protect itself.
Overcurrent Protection: If output current exceeds its rated value,
he controller will stop its output to protect itself and the load.
Restorable Short Circuit Protection: If the output of the
controller is short-circuited, the controller will shut down its
output to protect itself and the load. But the fuse inside will not
be blown. So when there is no short circuit at the output side, the
controller will work again after powering on.
